Furman M-8S Power Conditioner with Power Sequencing

Merit M-8S Power Sequencer is the perfect low-cost AC power solution for any rack mount system. Install an M-8S in your rack, and the eight outlets in the rear panel will power up in sequence and protect all your equipment up to a 15-amp load.The M-8S represents an excellent combination of value and performance and has been
designed to provide many years of reliable service.Get hip to the new power revolution and learn about the many features and benefits that the Merit M-8S has to offer.

Features:

• Standard level AC protection and filtering.
• Six sequenced rear panel outlets (in 3 groups), two unswitched rear panel outlets, and one front panel unswitched outlet.
• Momentary and Maintained sequencing via rear panel terminal block or front panel switch (momentary only).
• Merit Class Surge Protection Provides basic Line to Neutral Surge protection with zero ground leakage.
• RFI/EMI filtration - Pi type LCR filter gives greater than 26dB of attenuation from 100 KHz to 1 MHz.
• Remote Interface Legacy style interface with Phoenix style connector allows remote operation and compatibility with Furman legacy equipment.
• Thermal Circuit Breaker - Rated 15Amps at 120VAC.
• Green LED - Indicators for status.
• 9 Outlets - NEMA 5-15R.
• 10 ft. Power Cord - NEMA 5-15P.
• All settings and configurations available on rear panel.
• 15 amp rating.
• Three year limited warranty.

Specifications:

• Maximum Output Current: 15 amps, 120 VAC (Thermal breaker)
• Line Cord: 14AWGx3, 10 feet, black, fixed, NEMA 5-15P plug
• AC Receptacles:
• Convenience Outlet (Front Panel) 1 Un-switched NEMA 15-5R
• Rear Panel Outlets: 2 Un-switched NEMA 5-15R (1 duplex),
• 6 Sequenced NEMA 5-15R (3 duplexes, each controlled by separate relay)
• Standard level AC Surge Protection : Merit Class (sacrificial)
• Spike Protection Mode : Line to neutral, zero ground leakage
• Max Continuous Operating Voltage : 130V RMS
• Max Clamp Voltage : 500 Volts Peak
• Peak Impulse Current : 12,000 Amps
• Energy Rating (2 X 820I¬S) : 225 Joules
• AC Filtering : Standard level Pi LCR Filter
• Noise Attenuation : >26dB, 100 Khz to 1 MHz
• Operating Temperature Range : 5C (40F) to 40C (105F) degrees
• Humidity Range :
• Rocker Switch : Front panel, Sequence (ON, OFF)
• Thermal Circuit Breaker : Front panel, push to reset
• Front Panel Indicators : Delay 1, Delay 2, Delay 3, Power, Protection OK
• Rear Panel DIP Switches : 12V Mode On/Off, GND Mode On, Momentary/Maintained
• Potentiometer : Rear panel, time calibration fine tune delay adjust
• Remote Terminal : +5-30VDC In, 12VDC (12mA) Out
• Remote Terminal : Phoenix type 4-Pin Connector with Screw terminals; +12V, STAT, REM, GND (Class 2 Wiring)
• Dimensions : 19"L x 8.75"D x 1.75"H ANSI 1RU
• Weight : 7 lbs.
• Power Consumption : 5 Watts
• Safety Agency : C/CSA/US